Jack is at it again with another scale rc heli project. Jack converts a Century Falcon SE 50 Nitro heli into a 5 bladed beastie that resembles Hughes 500MD and gives it electric power to boot.
In this review you will see the different modes that the Thunder AC680 supports (LiPo, NiCd, etc.) The charger can run either on Dc or on AC power (which is the case in the video). Next you will see how to charge a one cell battery, as well as a multi cell battery.
This tool will save you a decent amount of time when trying to level your swash plate on any type of rc helicopter. You don’t have to take off the whole head when using this tool, which results in time savings. The clear plate tool snaps onto the rod just underneath the swash plate and […]
Paul Bryant shows and explains how to make a vacuum mold tool, for stamping any canopy that you may want to create. The construction of the tool involves a few picture frames, vacuum, glass sheet, some screws, glue gun and your desired matrix or reproducible mold.
This newcomer to the scene of rc heli flying was having a difficult time adjusting the trim on his E-Flite CX2 controller so he had to do some extensive research to find out the solution. In other words his rc heli could not be held in the hover mode over the ground; it would go […]