![]() |
| |||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Walkera Talk about the Walkera.... |
| Our Sponsors |
| |
![]() |
| | Thread Tools |
|
#1
| |||
| |||
| First Flight 5#8 Set up was great, no problems found. It fly's very percise, very impressive! It was flown in doors. But.................it did have a movement every now and then that I did not input. I ran the antenna in side the tail boom and let about 18 in. hang out the back and the problem went away. |
|
#2
| |||
| |||
| Re: First Flight 5#8 Be carefull!! I noticed that the rear motor wires were rubbing the top main gear. So I re-routed it so it would not touch, I failed to note how the plug was positioned before I unplugged it. I thought it should be plugged in like the other motor plug,,,wrong. I was going to test fly her and smoke came from the rx and the rear moter did not turn, geuss I fried the receiver? I'm I safe to replace the receiver, or could the motor be damaged also? |
|
#3
| ||||
| ||||
| Re: First Flight 5#8 The safe thing would be to replace them both. I always try and replace any suspect parts.
__________________ Lama V4 , 22D , 35 , 36 35 Belt conversion. 3DX 400 SE Thunder Tiger Mini Titan W/ Kasama head Raptor 50 Titan ![]() AMA# 919244 |
|
#4
| ||||
| ||||
| Re: First Flight 5#8 The last thing you want is to have an in flight failure that will wind up costing you a hole lot more $$$$$
__________________ Lama V4 , 22D , 35 , 36 35 Belt conversion. 3DX 400 SE Thunder Tiger Mini Titan W/ Kasama head Raptor 50 Titan ![]() AMA# 919244 |
|
#5
| |||
| |||
| Re: First Flight 5#8 I agree, thanks. |
|
#6
| |||
| |||
| Re: First Flight 5#8 I have flown it for a total of about 1.5 hours since last post. I was inspecting it and noticed a crack on the plastic top shaft sleve. When I touched it with a srew driver it broke (or more like crumbled) into three peices! I did use blue lock tight on the srews that held it in place about a month ago? |
![]() |
| Our Sponsors |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|