Dark Knight 4CH 2 in1 ESC/Mixer Board Help

[shaolin]

Help need a wiring diagram to install the Mixer Board for Dark Knight part#SCR: EH45 (ESC/Mixer) board a PG-03 Gyro also wires in to middle of the rudder output on the 6-Channel Micro RX the Main Motor and Rudder Mixer on my old Dark Knight 4-Channel Heli.. One in it got tore out in crash lost power and it hit very hard messed up a lot of parts able to replace every thing then got to where needed to be wired up the Multi control board its not shown in manual as to how and all the wire ends have been tore or pulled out of their connectors? have searched net keep coming up with nothing no wiring diagram any place? So hope some one here has one and can help? It has 3 lines in or out in row top first one left to right 16 gage red/black wire with a red male keyed center one side like output on a 22E 603 RX to the main or tail motors next is middle wire it is a 16 gage red/black wire only stripped back ends no plug at all? One of these has to be input other output can't find out witch is it? Third wire is a small 2-pin mail plug mounted on board all in a row it was totally lost MIA, think it is the tail "rudder" motor plug? But not 100% sure size would point to this conclusion if correct? bottom same side 2- output leads to RX not sure witch one is where PG-03 Gyro gos in middle of the two from left too right black/red white long lead it has to be main motor throttle? Next is black/red white short lead being the short lead it has to be the Rudder Plug that runs to Gyro and then too RX from Gyro?
Any help would be very nice of any one have been trying to find a diagram for weeks got all the parts to rebuild it in a few days and its done! Just hate to guess and burn up a good part when there has to be a person that has a Dark Knight also out there. And can look at it and lend a little advise as to where the lead run?
Need Help Bad
shaolin