| |
| |||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Setting Up Questions Post your questions and answers on setting up your heli for the first time. |
| Our Sponsors |
| |
 |
| | Thread Tools |
|
#1
01-28-2008, 10:01 AM
| |||
| |||
| Honey Bee CP2 not lifting Hello all, newbie to all this and in need of some assistance. I have gone through what I can in terms of setup, made sure everything is level etc. I am able to power the heli up to full throttle and balanced the trim to keep it from moving around but I can't get any lift  Battery fully charged. The TRX throttle trim and stick are set as far back as possible. Also, the servo reveser switches at the bottom of the TRX don't seem to have any instructions in the manual, currently I have the AIL up (rev), ELE down (norm), THR up (rev) and RUD down (norm) - is this right? (last time I had the THR in norm I crashed it big time  determined to master this thing   |
|
#2
01-28-2008, 10:38 AM
| |||
| |||
| Re: Honey Bee CP2 not lifting OK, just managed to get it to lift off slightly but I think my setting are wrong. My TRX is mode 1 (throttle on the right side). I have to have the horizontal trim on the right side pretty far left. Suspect the reverser switches are wrong - anyone know the settings? (Getting excited - managed to get it off the ground and don't have buy spare parts!) |
|
| Our Sponsors |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
