Gyro Keeps Blinking

[ALIYC]

HI EVERYBODY, MY NAME IS ALI, I HAVE PURCHASED A BELT-CP EK1H-E015, WITH A FUTABA TRANSMITTER T6EXHP AND RECEIVER R146iP 35MHZ. BUT WHEN I CONNECT THE BATTER MY GYRO KEEPS BLINKING RED LIGHT, AND MY HELICOPTER DOES NOT RESPOND TO STICK MOVEMENTS ON MY TRANSMITTER. PLEASE HELP ME. REGARDS. ALI.

[alexroman]

hi ali
before you conect you batery make sure your transmiter is on and all trims are center and conect your batery and just wait for a 15 seconds, I hpe this will help you

[cdtocyou]

I had this problem right out of the box. My TX was bad.

[tom dubya]

I just had this problem and i finally got it working by putting the gyro switch on the radio in the down position. Not sure what the switch does but it worked.

[hawkman]

Probably the remote gain, I think the Gyro needs to be in heading hold mode to initialise itself.

Rob

[NiteKreeper]

My CX2 was the same - I was following the instructions to set the right-stick to 0 (ie 0% Throttle) in order to initialise, only to work out my Tx was in a different mode! (ie Throttle was right-stick!)
Setting the correct stick to 0% was all I needed...

Doesn't the CP have the same 3or4-in-1?

[///mik3]

I had the same problem on the CP2, only went green after I adjusted the Servo Reverser switches on the TX

[mcdonnea]

Hi Aliyc had the same problem with the Copterx i have the same transmiter i was playing around with the settings and put it in mode 1 were it should have been mode 2 try setting your speed controler to revers first.