Servos for Gohbee 90?

[shanee86]

I also have a question for you think I know the answer but just checking does your raptor 90 have a belt tail drive or a torgue tube tail drive?

[3dee]

yes its shaft driven I find it good in one sense its better drive never gos slack and its easy to take off the tail but when you smack it with a blade its over £20 more to fix.

[shanee86]

My other nitro heli has a direct shaft drive and I kind of like it but then again don't because gears were slipping sometimes so I was going to get metal gears but hobby shop hasn't got them yet. At first it didn't slip but started slipping later and is a pain. But my Gohbee 90 has a belt driven tail and they say it is better but I am not sure guess I will have to see.

[shanee86]

Been while since I been on here but so far I haven't got my helicopter done much at all . Why well because I got a girlfriend and she takes most of my money lol and also because or mainly because my step dad broke up with my mom and he was one who was going to help me with this setup. So I am trying to figure it out myself and get all the parts still.

[3dee]

the best way on your own is to down load the manual and do it by that. all link rods sizes are there and set up for throttle and pitch for tx are there as well so unless you are 3d std. it should be fine