Servos to Receivers.......

Can someone with KNOWLEDGE of the Raptor 30 please tell me or show me a site that has exact locations for the connections between the Servos and Receiver?

I have no instructions or manuals to this thing.

I have a Futaba (dual conversion, if that means something) receiver. it has 8 open slots.

7. - Volt Watch ?
6. - Pitch ?
5. - RX AUX (SG-10 gyro) ?
4. - RX RUD (SG-10 gyro) ?
3. - Throttle ?
2. - Elevator ?
1. - Aileron ?
B/8 - On/Off ?

SG-10 Airtronics Gyro Mixer. (from top to bottom as looking head on)

1. plug gyro Sg-10 in here?
2. Rudder Servo Here?
3. slot 4 on receiver ?
4. slot 5 on receiver?

Are these FOR SURE THE RIGHT LOCATION ?

Thanks for the help and info..........

o.k

rudder servo in gyro there usualy is a connecter where it goes into then you have two more from the gyro .
one goes in ch#4
the other in ch#5 this one is where you alocate a switch so you have two settings on the gyro or in the transmiter for the gyro.
so you can have a solide hover setting than swich to fast foward
flight if the tail rotor fish tails you can adjust setting #2 till it stops wiggling and youre all set.

hope this is what you needed

steff