| |
| |||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| R/C Helicopter Radio and Gear Talk about Futaba, Airtronics, JR , Hitec, servos, gyros, receivers and... |
| Our Sponsors |
| |
 |
| | Thread Tools |
|
#1
09-27-2004, 09:58 AM
| |||
| |||
 Where to connect gyro?? I have just built my new helicopter but i have 2 different bits of information on where to plug in the gyro!! The gyro is a GWS PG-03, and its instructions say's to connect it to the rudder servo and the rudder socket (Number 4) on the RX. The TX is a SANWA RD6000 Sport and its instructions say's that the Gyro goes onto Socket number 5 on the RX. Which one should i do??? Any help or advice would be greatful. Regards Andy. Andyw114@hotmail.com  |
|
#2
09-30-2004, 06:45 PM
| ||||
| ||||
| I used to use the PG03 and never had any problems with it connected to channel 4 on the receiver. Be sure to make sure that it is working the right way. the servo is then pluged into the gyro. Darren.  awake now 
__________________ Regards Darren If you cant fly. dont quit trying.   Last edited by Daz(DJLFlapper) : 10-01-2004 at 11:11 PM. |
|
| Our Sponsors |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
