| |
| |||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| R/C Helicopter Radio and Gear Talk about Futaba, Airtronics, JR , Hitec, servos, gyros, receivers and... |
| Our Sponsors |
| |
 |
| | Thread Tools |
|
#1
04-07-2007, 12:16 PM
| ||||
| ||||
| Blade CP servo question I am debating doing the HDX-300 conversion to my CP. My question is can you use the stock 4-1 with this setup and if you can how do I hook up the tail servo. If I cant use the 4-1 then what else will I need to make this happen? Thanks Last edited by shovelracer : 04-09-2007 at 11:25 AM. Reason: Change of question  |
|
#2
04-08-2007, 04:34 PM
| ||||
| ||||
| Re: Blade CP belt drive rear servo question I am sorry I am not sure that I can help you with this one. I will do some research but I don't think that this is possible. trying to get the tail mixing to work is your biggest problem from what I can tell. I could be wrong, Come on guys if I am chimb in 
__________________ Regards Darren If you cant fly. dont quit trying.   |
|
#3
04-09-2007, 11:32 AM
| ||||
| ||||
| Re: Blade CP belt drive rear servo question OK never mind, I reverted back to the stock setup using the cnc swash plate and blade grips. Everything is cool now. The metal setup was much heavier than before and the heli could barely lift off the ground. New question is what would I need to do to use HS-55 servos on the CP with the stock radio. I know they throw in the opposite direction and you can get everything to work right except that the throttle stick would opperate in reverse and cause negative pitch on throttle up. Can anything be rewired to make it work. Or can you think of a good project to use 3 HS-55's? |
|
| Our Sponsors |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
