6EXHP and Eflite 4 in 1's

[hawkman]

If you are going the TRex route then take a look at this site

www.trextuning.com

its a good site...I dont own a Trex just yet...my Boss at work does...very nice little heli it is too....parts are cheap and seem plentiful...an accident shouldnt break the bank....this is crucial...if a prang is going to cost a lot to repair then its better to find a cheaper heli.

Fitting decent radio gear is a great idea....the Align stuff was a mix and match...but the radio was a JR Propo...good radio...but the 'patch' to make the eCCPM work was ridiculous (My Boss's heli...and setup) this particular heli had been bought as a package deal.

Pays to get two batterys for the Trex as well...you'll like this heli.

Rob

[ArrowNaughtic]

thanks Hawkman for that link. Sweet looking heli when all said and done. With a gyro, servos and whatnot looks like about $800 to get flying. I already have a reciever I am not using....heh.
I do have a question if anyone knows how to go abvout this one. With this eCCPM swash type, and a CNC head, I can't seem to figure out how to get the blade pitch to be reversed when advancing the throttle. On a stock setup all 3 servos pull down increaing the pitch of the blades when advancing the throttle. I need the swash to go up when advancing the throttle. Any suggestions? Would I change the swash settings in the radio and then reverse the AIL.ELE and PIT channels?