Belt cp help PLEASE!!!!! :)

[joshy987]

hey

i just recently got into rc heli flying and i bought a Esky Belt CP as my first heli

i have been practicing on the simulator for 2 weeks and i went to fly it. I plugged it in and powered it up it then started to spin clockwise and the only way to stop it was if i pushed the rudder stick all the way to the otha side but then it jst flipped ova and broke one of the blades so then i had to buy new blades. i dont want to go and put the new blades on and try again untill i have foound out why the heli was spinning that way

has anyone got any ideas?????

thanx you alot

[BABY HUEY]

First, This is why you should use training gear on a new heli. Second, The spinning problem is the most common one as the gyro probably needs to be reversed, as long as the Tx is settings are correct.

HTH
Huey

[dasbeermeister]

First thing you need to do is make sure your tail servo is centered. Remove the horn on the servo thats on the tail boom, turn on your transmitter and heli and center the trim for that servo. Then make sure you have the slider on tail rotor centered and re-install the horn. If the heli still wants to spin on you you may need to adjust the gyro. I'm not the best at gyro adjustments so hopefully someone that is will put in their 2 cents on that.

[joshy987]

thank you so much to the both of you i will try that as soon as i wake up tomorrow lol. oh and i did have training gear on lol hahaha

once again thank you alot and i will right how i got on

thanx josh