HELP!!Esky co-comanche turns bears left when flying forward

[KDiddy1234]

When I push straight on the control stick to fly forward the copter bears left. I've tried trimming it and adjusting the 4in1 Mix Controller but still the same. The Servo's seem to be working normally they move when I move the stick. In order to move forward, I have to make it bear right to compensate while pushing the stick forward some.

Any suggestions?

[Miklovo]

has it always done this? or did it just start?
There are 3 links that connect your lower blade to the swash plate. One of these links maybe be set longer than the others, you may have to screw it down a little.

Mine came out of the box where the rear right link was like this, it made my heli slightly lean to the left in forward flight.

good luck

[KDiddy1234]

Thanks Miklovo for your reply! No actually it didn't always do it but the problem is I'm not sure when it started. I had a few crashes but nothing horrible. Broke a few blades thats about it.

Whats crazy is I did adjust the servo rod....but had made it longer, not shorter. This stopped the problem I had where it would drift backwards even when the forward/backward trim was pegged forward. Now its centered.....

If you look at the copter from the back to the front, the swashplate looks like its tilted forward and to the right.....and when you push the stick to move forward the servo moves the arm so its even more in that direction...yet.....it pulls to the left.....from a physics standpoint this doesn't make any sense.